With our paintable cap and dividers use easy to apply primer and plastic aerosol paint to perfectly color match your project to complement any living space.
Fastening vinyl lattiuce caps.
Adding vinyl or wooden lattice beneath a porch or deck can give it a fresh new look.
The moulding attaches to your frame and the lattice floats inside the channel.
Deckorators plastic lattice can be cut and drilled using standard tools.
Installing lattice is easy and relatively inexpensive.
Available in all 12 of our lattice colors in addition to the exclusive paintable lattice makes it simple to coordinate your look.
I had to replace a couple vinyl lattice sections that w.
The easiest way to cut a vinyl lattice is with a circular saw.
This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.
Once you have installed the lattice panels you trim and attach wooden or vinyl lath type molding or planks to conceal the edges of the lattice panels.
California redwood vinyl lattice cap 2 pack the 0 75 in.
Under deck install wooden blocks or stakes as support points if none are available.
Lattice also hides unsightly areas such as the floor joist or posts.
For a distinguished look frame panels with plastic caps and connect panels with plastic dividers fig.
Woodland the 0 75 in.
In addition lattice can be used to create hidden storage space beneath your deck or porch.
Allow a 1 4 gap on all sides for expansion with cap and divider moldings.
Easiest install is using the vinyl cap moulding.
A lattice sheet should be supported a maximum distance of every 4 feet.
The moulding features a vinyl construction that is both weather and impact resistant.
The result is a smoother cleaner cut sheet of lattice.
Woodland green vinyl lattice cap moulding is designed to finish the edges of your lattice panels not included.
Find lattice screws wood screws at lowe s today.
Then you position the trimmed lattice panel level it and fasten it to the posts and rails with nails or screws.
Use rustproof or rust resistant fasteners to maintain the beauty of your project over time.
Always allow a 1 4 gap between the lattice edge and.
